OPERATINg YOUR DRYER
1. Ready mode
1) Coin / Card type
- The cycle LEDs flash at the same time, when the
price of cycles are equal.
2) OPL type
- The cycle LEDs is lit at the same time, and displayed
PUSH.
2. Insert card/coin/token
(not for OPl type)
Insert a cash card that has a sufficient balance.
The card balance should be more than the
programmed vend price for a selected cycle.
NOTE
When the card balance is not enough, machine
displays the balance for 5 seconds and then displays
message repetitively.
Insert a sufficient amount of change that is a more
than the programmed vend price for a selected cycle.
NOTE
When the coin amount is not enough, the machine
will not start.
3. Select the cycle
Press the desired cycle and the start button. The display
LED will show the remaining time and the selected cycle
starts.
NOTE
Owner can control the cooling time in
progamming mode.
All manuals and user guides at all-guides.com
4. Top off (To add more time)
After a debit card is inserted, the operating time can
be increased to 5 minutes/ 25¢ (default), when the
Start button or the chosen course button has been
pressed.
(The card should have enough balance to satisfy
increasing time.)
The operating time can be increased to 5 minutes/
25¢ (default) by adding more coins.
Owner can control the additional time and money
setting (top off price).
When the COOL DOWN has been working, if time is
added, it goes back to the DRYING.
Time can be added up 99 minutes.
5. Change cycle
You cannot change the cycle while the machine is
running.
But if the door is opened, the machine stops
temporarily and the cycle can be changed.
6. Cycle finish
After the COOL DOWN of cycle, the machine stops
and LED display shows End.
If you press any key or open the door, the dryer
defaults to the ready mode.
of
OPERATING YOUR DRYER
NOTE
15