3-4. Top off apply or not setup
Entering set up
mode.
You will see lqC1
Press the High Temp. button.
Press the med Temp. or the low Temp. button until
appears in the display.
Press the Start button.
Press the med Temp. or the low Temp. button until
appears in the display.
Press the Start button.
Display
Press the med Temp. or the low Temp. button until
appears in the display.
Press the Start button.
Press med Temp. or low Temp. button and then select
Press the Start button.
The machine sets up the Vend type, then advances to the next
process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/off toggle switch
• Card type - Pull the service card
• OPL/Coin type – Press "High Temp. " twice
NOTE
• tEIn (Twin spray apply or not) is not available in dryer.
All manuals and user guides at all-guides.com
Button
.
or
.
Disable
Enable
PROGRAMMING MODE
Display
One or the other will
display.
25