Programming Mode - LG TCD1870QGS Manual De Usuario

16

PROGRAMMING MODE

PROgRAMMINg MODE
Programming mode
You can check machine information or change setting on program setup or diagnostic test.
There are two methods that you can enter programming mode.
How to enter Programming mode
You can enter programming mode only for Idle state
and pause state.
- Card Type
1) Insert service card.
2) Display will show
- Coin Type
1) Dissemble upper coin box key.
2) Take out the coin drop from the coin box.
3) Turn on/off the toggle switch at the back of the coin
box.
4) Display will show
- OPl/Coin Type
1) Push the High Temp. and Low Temp. button at the
same time.
2) Push the Med Temp. button 3 times.
3) Push the Start button.
4) Display will show
- Stack Type
1) Open control panel.
2) Turn on/off toggle switch in front of panel frame.
3) Display will show
Coin Box Key
Coin Vault
Openinngs close
Coin type
NOTE
• If you turn on the power without connecting the meter case for the first time, the machine will display
• When the machine comes from the factory, it is set in the coin type. You can change Card/Coin type by button.
(For more information refer to SETUP modes
• The machine will display PUSH for OPL type
All manuals and user guides at all-guides.com
You can change dryer vend price, cycle time and cycle
parameters, etc.
Card type
/
How to use button
Press button
High Temp. Move to upper level
Move to the mode in the
Med Temp.
Move to the modes in the
Low Temp.
No Heat
Start Enter the selected mode
.)
Description
same level (+)
same level (-)
-
Stack coin type
OPl type
.