Care And Cleaning; Troubleshooting; Installation - AEG HE604060XB Manual De Instrucciones

16 www.aeg.com

6. CARE AND CLEANING

Clean the appliance after each use.
Always use cookware with clean bottom.
Scratches or dark stains on the
glass-ceramic cause no effect on
how the appliance operates.
To remove the dirt:
1. – Remove immediately: melted
plastic, plastic foil, and food with
sugar. If not, the dirt can cause
damage to the appliance. Use a
special scraper for the glass . Put
the scraper on the glass surface at

7. TROUBLESHOOTING

You cannot activate the
appliance or operate it.
The residual heat indica-
tor does not come on.
You cannot activate the
outer ring.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an
error message that comes on.

8. INSTALLATION

WARNING!
Refer to the Safety chapters.
Problem
2.
3.
Possible cause
Problem with the house
electrical system.
The cooking zone is not
hot because it operated
only for a short time.
Make sure, you operated the appliance
correctly. If not the servicing by a cus-
tomer service technician or dealer will
not be free of charge, also during the
warranty period. The instructions about
the customer service and conditions of
guarantee are in the guarantee booklet.
an acute angle and move the
blade on the surface .
– Remove after the appliance is
sufficiently cool: limescale rings ,
water rings, fat stains, shiny metal-
lic discolorations. Use a special
cleaning agent for glass ceramic
or stainless steel.
Clean the appliance with a moist
cloth and some detergent.
At the end rub the appliance dry
with a clean cloth.
Remedy
Activate the appliance
again and set the heat
setting in less than 10
seconds.
Examine the fuse in the
electrical system of the
house in the fuse box. If
the fuses blow again and
again, speak to qualified
electrician.
If the cooking zone
should be hot, speak to
the service centre.
Activate the inner ring
first.
Before the installation