Metabo HPT CJ 18DA Manual De Instrucciones página 14

English
(1) Pull the lever in the direction indicated by the arrow.
(Fig. 8-І)
(2) With the lever pulled, insert the blade until it butts
against the outlet of the blade holder tip. (Fig. 8-ІІ)
(3) Release the lever. (Fig. 8-ІІІ)
Lever
Blade
Guide roller
holder
Fig. 8-І
NOTE
○ Confi rm the protrusions of blade inserted to the blade
holder surely.
○ Confi rm the blade located between the groove of
roller. (Fig. 9)
Blade
Roller
5. Adjusting the orbital operation
(1) This Jig Saw employs orbital operation which moves
the blade back and forth, as well as up and down. Set
the change knob shown in Fig. 10 to "0" to eliminate
the orbital operation (the blade moves only up and
down). The orbital operation can be selected in 4
steps from "0" to "III".
14
Blade
Roller
Fig. 9
Change knob
Fig. 10
Blade
Fig. 8-ІІ
(2) For the hard material, such as a steel plate, etc.,
decrease the orbital operation. For the soft material,
such as lumber, plastic, etc., increase the orbital
operation to increase work effi ciency. To cut the
material accurately, decrease the orbital operation.
6. Cutting stainless steel plates
This Jig Saw can cut stainless steel plates by using
No. 97 blade (sold separately). Carefully read
"Concerning cutting of stainless steel plates" for
proper operation.
7. Splinter guard
CAUTION
Be sure to switch OFF and disconnect the
battery from body.
Using the splinter guard when cutting wood materials
will reduce splintering of cut surfaces.
Using the provided hexagonal bar wrench, tighten the
bolts in the lower area of the base, moving the base
as far forward as possible. (Fig. 11)
Base bolt
Base
Blade holder
Guide roller
Fig. 8-ІІІ
Hexagonal bar wrench
Fig. 11
Plunger