Troubleshooting Guide - Metabo HPT CJ 18DA Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

● To avoid injury from an accidental start, turn the switch OFF and remove the plug from the power source
or remove the battery from the main body before making any adjustments.
● All electrical or mechanical repairs should be done only by qualifi ed service technicians. Contact
metabo HPT Authorized Service Center.
Symptom
Tool doesn't run
Tool suddenly stopped
Blade
- can't be attached
- fall off
Switch can't be pulled
An abnormal high-pitched
noise occurs when the
switch trigger is pulled.
Blade wears out too quickly. Proper machine oil not used when
Unable to properly cut.

TROUBLESHOOTING GUIDE

WARNING
Possible cause
No remaining battery power
Battery isn't fully installed.
Tool was overburdened
Battery overheated
The shape of the attachment portion
doesn't match
The lever is open.
There is foreign matter inside the blade
holder.
Lock-off button is pushed in.
The switch trigger is being pulled only
slightly.
cutting metallic materials
Too much applied pressure during
operation
Blade is inappropriate for the quality and
thickness of the material to be cut
Speed and orbital position are
inappropriate for the quality and
thickness of the material to be cut
Blade is worn, degraded or damaged
Remedy
Charge the battery.
Push the battery in until you hear a click.
Get rid of the problem causing the
overburden.
During operation, lighten the applied
pressure.
Allow the tool and battery to thoroughly
cool.
Use the appropriate blade
(See "Table 7" on page 25)
Close the lever.
Remove the foreign matter.
Release the Lock-off button.
This is not a malfunction.
It does not occur if the switch trigger is
pulled more fully.
Use machine oil (turbine oil, etc.)
During operation, lighten the applied
pressure.
Use the proper blade
(See "Table 7" on page 25)
Set the appropriate speed and orbital
position
(See "Cutting" on pages 18 – 20)
Replace with a new blade.
English
23

Publicidad

Tabla de contenido
loading

Tabla de contenido