Stihl HS 75 Manual De Instrucciones página 21

English / USA
5
:
Use a screwdriver to ease the cap
out of the starter grip.
:
Remove remaining rope from the
rotor and grip, making sure the
ElastoStart sleeve is not pushed out
of the grip.
: Tie a simple overhand knot in the
end of the new starter rope (see
"Specifications") and then thread
rope through the top of the grip and
the rope bushing (5).
:
Refit the cap in the grip.
20
:
Pull the rope through the rotor and
secure it with a simple overhand
knot.
:
Lubricate rope rotor bore with
non-resinous oil.
: Push rotor onto the starter post –
turn back and forth until loop (6) of
rewind spring engages.
: Insert screw and tighten down
securely.
Go to "Tensioning rewind spring".
Replacing a broken rewind spring
:
Lubricate the new spring with a few
drops of non-resinous oil, do not
open the wire retainer
:
Remove the rope rotor.
: Remove parts of old spring.
:
Fit the new spring –
position outer spring loop in the
recess –
the wire retainer slips off in this
process.
HS 75, HS 80