Stihl MS 311 Manual De Instrucciones página 43

Replace torn starter rope
2
3
4
N Carefully press the spring clip (2) off
of the axle with a screw driver or
suitable pliers
N Carefully remove the rope rotor with
washer (3) and pawls (4)
The rewind spring can jump out –
risk of injury!
N
Lever the rope out of the starter
handle with a screwdriver
N Remove the remainder of the rope
from the rotor and starter handle
N
Thread the new starter rope through
the starter handle and secure it by
making a special knot
N Pull the knot into the starter handle
MS 311, MS 391
4
5
N Thread the rope from above through
the rope guide bush (5) and rope
rotor (6) and secure with a simple
knot
N
Coat the bearing bore in the rope
rotor with non-resinous oil
N Slip the rope rotor onto the starter
post (7) – turn it back and forth a
little until the anchor loop of the
rewind spring engages
N
6
7
N
Tension the rewind spring
N
N
N
N
2
3
4
4
Refit the pawls (4) in the rotor and
slip the washer (3) over the starter
post
Press the spring clip (2) on to the
starter post and over the pegs of the
pawl with a screwdriver or suitable
pliers – the spring clip must point in
the clockwise direction – as in the
picture
Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow
Hold the rope rotor tight – pull out
the twisted rope and untangle it
Release the rope rotor
Slowly let go of rope so that it winds
onto the rotor
English
41