Cutting Attachment; Mounting The Bar And Chain - Stihl MS 311 Manual De Instrucciones

Ocultar thumbs Ver también para MS 311:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cutting Attachment

STIHL is the only manufacturer in the
industry to produce its own chain saws,
guide bars, saw chains and chain
sprockets.
A cutting attachment consists of the saw
chain, guide bar and chain sprocket.
The cutting attachment that comes
standard is designed to exactly match
the chain saw.
1
a
t = a : 2
The pitch (t) of the saw chain (1),
chain sprocket and the nose
sprocket of the Rollomatic guide bar
must match.
The drive link gauge (2) of the saw
chain (1) must match the groove
width of the guide bar (3).
If non-matching components are used,
the cutting attachment may be damaged
beyond repair after a short period of
operation.
MS 311, MS 391
Mounting the Bar and
Chain
Removing the chain sprocket cover
N
Unscrew the nuts and take off the
2
chain sprocket cover.
3
2
N
Turn the screw (1)
counterclockwise until the tensioner
slide (2) butts against the left end of
the housing slot.
Disengaging the chain brake.
N
Fitting the chain
1
N
Pull the hand guarad towards the
front handle until there is an audible
click – the chain brake is
disengaged.
Wear work gloves to protect your
hands from the sharp cutters.
Fit the chain – start at the bar nose.
English
23

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Ms 391

Tabla de contenido