PRESIDENT JOHNNY II ASC Manual Del Usuario página 32

4) CHANNEL SELECTOR ROTARY KNOB:
Turning this knob allows you to choose a channel (1-40) for transmitting and receiving.
5) DISPLAY:
The display shows all the different functions. The bargraph shows the level of
reception and the level of power emitted. The TX LED lights up when the set goes into
transmission mode.
6) FREQUENCY BAND SELECTION
The frequency bands must be chosen according to the country where you are going
to operate. Do not use another configuration. Some countries require user's licence.
a) Radio set switched OFF.
b) Slide the F/OFF switch on F position.
c) Switch ON the radio.
d) Choose the request configuration with the channel rotary switch (see the chart p. 48).
e) Slide the F/OFF switch on OFF position.
f) And then, for final confirmation of the choice before operating in the configuration,
switch OFF then ON the radio set.
7) HI-CUT:
Cuts out high frequency interference. Its use depends on reception conditions.
To activate this function, move the switch to HI-CUT position. Move the same switch
to OFF position to deactivate.
8) CH 19:
Channel 19 is automatically selected when you activate this switch.
To activate this function, move the switch to CH19 position, and to return to the
previous channel move the same switch to OFF position.
9) 6-PIN MICROPHONE PLUG:
This plug is situated on the front panel, thereby making it easier to set the equipment
into the dashboard. See the cabling diagram on page 47.
10) PTT (push to talk):
Depress this knob to transmit a message and release to listen to an incoming
communication.
A) DC-POWER TERMINAL (13,2 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL SPEAKER JACK (8 W, Ø 3,5 mm)
32