Input Terminals; Using The Ir Port; Error Codes - Beha-Amprobe Telaris ProInstall-100-EUR Manual Del Usuario

Input Terminals

Use the rotary switch to select the type of test you want to perform.
42
Number Description
L (Line)
42
43 PE (Protective Earth)
44 N (Neutral)

Using the IR Port

The Model Telaris ProInstall-100 and Telaris ProInstall-200 have an IR (infrared) port, see
Figure 23, which allows you to connect the tester to a computer and upload test data using
a Amprobe PC software. This automates your troubleshooting or recording process, reduces
the possibility of manual error and allows you to collect, organize, and display test data in
a format that meets your needs. See "Uploading Test Results" on page 40 for additional
information on using the IR port.

Error Codes

Various error conditions are detected by the tester and are indicated with the
"Err", and an error number on the primary display. See table below. These error conditions
disable testing and, if necessary, stop a running test.
Error Condition
Self-test Fails
Code
1 Return the tester to a Amprobe Service Center.
43
Figure 6. Error Display
Solution
8
44
W
icon,