Fax +1 305 430 9280
USEFUL ADVICE ON TOASTING
If the toasted bread pieces are too small to be picked up easily
•
from the toaster, simply raise the bread carriage handle to its
uppermost position (High-lift function), to lift the carriage and pick
up the toasted bread. If still not accessible, please use thin heat-
resistant tongs to pick up the bread in the slot.
Do NOT touch the metal parts as they will be hot!
•
For pop tarts or frozen waffles, please follow the instruction on the
•
box.
Do NOT toast food, other than bread, that is not specifically said
•
to be toasted in a slot toaster.
If the toaster jams, the bread might simply be too thick. Remove
•
the bread from the toaster and slice it thinner.
The second or third toast might toast too dark. This is normal. In
•
case of repeated, successive toasting, it might be useful to adjust
the browning level so that the second toasts' browning is
consistent with the first.
MAINTENANCE AND CLEANING
Before attempting any cleaning operation, make sure the toaster
•
is unplugged from the supply socket and fully cooled down.
To remove bread crumbs, slide the crumb tray (9) situated on the
•
bottom of the appliance, out from the side for removal (Fig. 2)
Caution! It is very important to empty the crumb tray regularly.
•
Crumbs that have accumulated in the toaster might burn and
may become a fire hazard.
To clean the exterior surface/housing, simply wipe over with a
•
soft, damp cloth. Do not use abrasive cleaners or material
(scouring pads) as they may damage the finish of your
appliance.
To clean the interior glass panel, make sure the crumb tray is
•
empty, turn the toaster upside down or on the side and press on
the clamp situated underneath the base, on the handle of the
interior glass panel. Cautiously slide the interior glass panel out of
the toaster for cleaning. The interior glass panel can be washed in
warm soapy water. Rinse and dry cautiously, then put the glass
panel back in place and slide it into its grooves until the clamp
can maintain the glass panel securely in place (Fig. 3).
Copies of the I/B. Please reproduce them without any
changes
except
under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
6
Assembly page 6/28
special
instruction
from
Team
Print only
TO 39085 - 120501