Bushnell NatureView HD Essential Manual De Instrucciones página 9

4.0x1.7mm coaxial DC power plug with positive "tip" (inside pin) polarity
(Radio Shack P/N 274-1532 or equivalent).
If both an external power source is connected and batteries are installed, the
NatureView HD Essential will be powered by the external power source.
When the batteries become weak, the low-battery indicator LED will glow
blue, indicating the batteries should be changed (pg 7, "Front View").
Inserting the SD Card
The NatureView HD Essentials have 32MB internal memory, which can
hold only about 10 photos (@ 5MP resolution). This is handy for testing and
getting familiar with the camera, but you will no doubt want to leave the camera
unattended for longer than a day, so using an SD card is recommended. Insert
the SD card (with the camera's power switch in the OFF position) before
beginning to operate the camera. Don't insert or remove the SD card when
the power switch is in the ON position.
The NatureView HD Essential uses a standard SD (Secure Digital) memory
card to save photos (in .jpg format) and/or videos (in .avi format). SD and
SDHC (High Capacity) cards up to a maximum 32GB capacity are supported.
Before inserting the SD card into the card slot after opening the camera's
front cover, please make sure that the write-protect switch on the side of the
card is "off" (NOT in the "Lock" position). The following describes how to
insert and remove the SD card:
• Insert the SD card into the card slot with its label side upwards (see
above). A "click" sound indicates that the card is installed successfully.
If the wrong side of the card is facing up, you will not be able to insert
it without force-there is only one correct way to insert cards. If the SD
card is not installed correctly, the device will not display an SD card icon
on the LCD in SETUP mode (the SD card icon displayed after switching
to SETUP mode will have a "lock" symbol inside it in it if the card is locked).
Formatting the SD card by using the NatureView HD Essential's
"Format" parameter before using it for the first time is recommended,
especially when a card has been used
in other devices (see "Changing Menu
Parameter Settings" for details).
• To take out the SD card, just gently push
in the card (do not try to pull it out without
pushing in first). The card is released from
the slot and ready to be removed when you hear the click. Be sure the
9