Electrical Connection - Thermo Scientific ES Serie Manual De Usuario

The equipment is intended for connection to alternating current. The connection values for
voltage (V) and frequency (Hz) are declared on the name plate in the cabinet. Power must be
connected via a wall socket with a switch. It is strongly recommended that the wall socket is
easily accessible. All earthing requirements stipulated by the local electricity authority. The
cabinet plug and wall socket should give correct earthing. If in doubt, contact your local
supplier or an authorised electrician.
WARNING: THIS EQUIPMENT MUST BE EARTHED
The flexible cord (mains lead) fitted to this equipment has three cores for use with a 3-pin 13
amp plug. If a BS 1363 (13-amp) fused plug is used it should be fitted with a 13-amp fuse.
The cores in the mains lead are coloured in accordance with the following code:
GREEN AND YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
These colours might not correspond with the colour markings identifying the terminals in
your plug.
Note:
First Connection to the mains
The equipment provides information about the higher temperature (Hi alarm) till the moment
of cooling.
The alarm is signalised by a sound signal and "Hi" caption on the display. To cancel the
alarm, press any button.
Until the moment of cooling, the alarm is repeated every 15 minutes. Such an operating mode
is normal until the required temperature settings are reached.
Green & Yellow
Blue

Electrical Connection

13 Amp Fuse
Brown
Cord clamp
15