Intended Use And Special Warning; Before First Use; Positioning Of Refrigerator - Thermo Scientific ES Serie Manual De Usuario

Intended Use and Special Warning

This equipment is tested in compliance with established regulations and then shipped ready
for use. This equipment is intended for general purpose cold storage and is not to be used in
the presence of explosive gases or mixtures and / or close to sources with high magnetic or
electric fields. Not intended for flammable material storage.
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
Thank you for purchasing this ES Series cold storage equipment. Before you first use this
laboratory refrigerator please carry out the following actions:
• Check that the refrigerator has not been damaged in any way during transportation.
•
If any damage is found it must be reported to your local dealer immediately
• Ensure all packaging has been removed, including cardboard, polystyrene and any
tape used to hold shelves in place for transportation.
• The refrigerator has been cleaned prior to despatch; however, we advise that it should
be cleaned using lukewarm water containing a mild detergent and a soft cloth.
• We recommend that the refrigerator should be left in an upright position for 24 hours
prior to switching on.
• This equipment is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the equipment by a
person responsible for their safety.
• Children should not be allowed to play with the equipment.
Positioning and safely using your ES series refrigerator
• Warning to reduce the risk of the unit falling over, do not tip beyond 10 degrees
• Make sure the equipment is placed in a dry, well ventilated site, away from heat
sources.
• The equipment must be placed on a level surface. If necessary, adjust the feet on the
product so the equipment remains level during operation.
• The equipment should have sufficient clearance around it to provide adequate
ventilation – 10cm at each side, 6cm at the rear and 2.5cm at the top.
• Before ANY maintenance activity, pull the plug out of the socket by gripping the
plug, DO NOT pull on the plug cord.
• DO NOT use double-wire extension cords. If an extension cord is necessary make
sure it is a cord, which possess a protection safety certificate.
• If the main power supply cord is damaged, it should be replaced by a qualified service
engineer.
• DO NOT attempt any repairs to the equipment yourself (apart from those highlighted
in the Maintenance and Service Section). Repairs carried out by someone without the
relevant training are putting their personal safety at risk and will invalidate your
warranty.
• WARNING: this equipment is only to be operated by authorised personnel or
personnel who have correct knowledge on how the equipment operates.
3