Lubricating The Gearbox; Replacing The Starter Rope And Rewind Spring - Stihl FS 100 RX Manual De Instrucciones

Lubricating the Gearbox

1
2
Check lubricant filling periodically
N
and after approx. every 25 hours of
operation
Unscrew the locking screw (1) – if
N
no grease can be seen on the
inside, then screw in the tube (2) of
STIHL gear lubricant for
brushcutters (special accessory)
Squeeze up to 1/5 oz (5 g) of
N
grease into the gear housing
Do not completely fill the gear housing
with grease.
Unscrew lubricant tube (2)
N
Refit locking screw and tighten
N
securely
FS 100 RX
Replacing the Starter Rope
and Rewind Spring
Replacing the Starter Rope
1
2
1
Push the slide control in direction of
N
arrow h – to STOP-0.
Take out the screws (1).
N
Remove the starter cover (2) from
N
the housing.
1
Ease the spring clip (3) off the
N
starter post.
Remove the rope rotor with
N
washer (4) and pawl (5).
Remove the remaining rope from
N
the rotor and starter grip.
English
3
4
5
29