Fitting The Harness; Balancing The Trimmer/Brushcutter - Stihl FS 100 RX Manual De Instrucciones

English

Fitting the Harness

The type and style of the harness
depend on the market.
The use of the harness is described in
the chapter on "Approved Combinations
of Cutting Attachment, Deflector, Handle
and Harness".
Shoulder strap
2
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is level with your
right hip when the machine is
attached.
Balance the brushcutter.
N
22
Balancing the
Trimmer/Brushcutter
Attaching the unit to the harness
The type and style of the harness and
carabiner (spring hook) depend on the
market.
1
2
1
Attach the carabiner (1) to the
N
carrying ring (2) on the drive tube.
Loosen the screw (3).
N
Balance the brushcutter.
Adjust the carrying ring.
N
Tighten the screw moderately.
N
2
1
Let go of the brushcutter and check
N
to see how it is balance – the cutting
tool should just touch the ground in
the normal working position.
Move the carrying ring as required.
N
When the correct floating position has
been reached:
Tighten down the screw on the
N
carrying ring firmly.
Detaching the unit from the harness
Press down the bar on the
N
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
1
1
2
2
FS 100 RX