Fitting The Carrying Ring; Mounting The Cutting Attachment - Stihl FS 100 RX Manual De Instrucciones

Fitting the Carrying Ring

The carrying ring comes standard with
the machine or is available as a special
accessory.
1
1
2
For position of carrying ring see "Main
Parts".
Place the clamp (1) against the
N
drive tube with the tapped hole on
the left (viewed from engine).
Squeeze the two ends of the clamp
N
together and hold in that position.
Insert the M6x14 screw (2).
N
Line up the carrying ring.
N
Tighten down the screw firmly.
N
FS 100 RX
Mounting the Cutting
Attachment
Preparations
Lay your brushcutter on its back so
N
that the cutting attachment
mounting face is facing up.
Block the drive shaft.
Insert the stop pin (2) or screwdriver
N
– come standard with machine or
are available as special accessories
– in the hole (3) in the gearbox as far
as stop, and apply slight pressure.
Rotate the nut or cutting attachment
N
on the shaft (1) until the stop pin
slips into position and blocks the
shaft.
After mounting the cutting attachment,
remove the tool used to block the shaft.
Mounting the mowing head
Keep the instruction sheet for the
mowing head in a safe place.
STIHL PolyCut 20-3
Install only the mowing head with a
double-stepped seat as shown above.
English
17