Craftsman 247.88355 Manual Del Operador página 7

5. Remove the flat washer and hairpin clip from the end of the chute
directional control.
Insert the end of the chute directional control into the lower bracket
and secure with the flat washer and hairpin clip just removed.
If necessary, the lower bracket can be adjusted. Refer to Chute
Bracket Adjustment. on Page 20.
Adjustments
Auger Control
IMPORTANT: Prior to operating your snow thrower, refer to Auger
Control Test on page 12. Read and follow all instructions carefully and
perform all adjustments to verify your snow thrower is operating safely
and properly.
Skid Shoes
IMPORTANT: It is not recommended that you operate this snow
thrower on gravel as loose gravel can be easily picked up and thrown
by the auger causing personal injury or damage to the snow thrower.
The snow thrower skid shoes are adjusted upward at the factory for
shipping purposes. Adjust them downward, if desired, prior to operating
the snow thrower. Refer to Skid Shoes on page 13.
NOTE: If you choose to operate the snow thrower on a gravel surface,
keep the skid shoe in the position for maximum clearance between the
ground and the shave plate.
Tire Pressure
Before operating, check tire pressure and reduce pressure in both tires
to between 15 psi and 20 psi.
NOTE: If the tire pressure is not equal in both tires, the unit may not
travel in a straight path and the shave plate may wear unevenly.
ASSEMBLY
5