Craftsman 247.88355 Manual Del Operador página 9

Auger Control
The auger control is located on the left handle. Squeeze the control
grip against the handle to engage the augers and start snow throwing
action. Release to stop.
Drive Control
The drive control is located on the right handle. Squeeze the control
grip against the handle to engage the wheel drive. Release to stop.
Chute Directional Control
The chute directional control is located on left side of the snow thrower.
To change the direction in which snow is thrown, turn chute directional
control as follows:
• Crank clockwise to discharge to the left.
• Crank counterclockwise to discharge to the right.
OPERATING YOUR SNOW THROWER
Ignition Key
The ignition key is a safety devise. It must be fully inserted in order for
the engine to start. Remove the ignition key when the snow thrower is
not in use.
Do not turn the ignition key in an attempt to start the engine. Doing so
may cause it to break.
Clean-Out Tool
WARNING: Never use your hands to clear
a clogged chute assembly. Shut off engine
and remain behind handles until all moving
parts have stopped before unclogging.
The chute clean-out tool is fastened to the top of the auger housing
with a mounting clip. The tool is designed to clear a clogged chute
assembly.
NOTE: This item (along with the electric starter's extension cord) is
fastened with a cable tie to the rear of the auger housing at the factory.
Cut the cable tie before operating the snow thrower.
Skid Shoes
Position the skid shoes based on surface conditions. Adjust upward
for hard-packed snow. Adjust downward when operating on gravel or
crushed rock surfaces.
Recoil Starter Handle
This handle is used to manually start the engine.
Electric Starter Button
Pressing the electric starter button engages the engine's electric
starter when plugged into a 120V power source.
Electric Starter Outlet
Requires the use of a three-prong outdoor extension cord (included)
and a 120V power source/wall outlet.
Augers
When engaged, the augers rotate and draw snow into the auger
housing.
Chute Assembly
Snow drawn into the auger housing is discharged out the chute
assembly.
Gas Cap
Unthread the gas cap to add gasoline to the fuel tank.
Oil Fill
Engine oil level can be checked and oil added through the oil fill.