Tabla de contenido
Publicidad
5-4 Fitting the Pedal Assembly
1.
Fit, finger tight only, the joint brackets to the coin tower, with
4off security button head screw (M5x12).
2.
Place the pedal assembly close to the coin tower and connect the
connector.
3.
Fit the pedal assembly inside the joint brackets, taking care not to trap
any wires and fit, finger tight, the 4off security button head screws
(M5x12).
4.
Ensure that the pedal assembly is flat on the ground and tighten fully the
4off security button head screws (M5x12) and the 4off security button
head screws (M5x12).
Page 39
Publicidad
Tabla de contenido
