Schumacher Battery Extender SP2 Manual Del Usuario página 8

8. If you've connected everything correctly, the CHARGING
orange) LED should be lit, indicating that the charger is charging, and the
POWER
check the connections or have the battery checked/replaced.
9. When the battery is fully charged, the CHARGED
10. When charging is complete, disconnect the charger from the AC power,
remove the clamps from the vehicle's chassis, and then remove the clamp
from the battery terminal.
CHARGING A BATTERY OUTSIDE OF THE VEHICLE
1. Place battery in a well-ventilated area.
2. Clean the battery terminals.
3. Connect the battery, following the precautions listed in sections 6 and 7.
4. Connect the charger to the electrical outlet. The POWER
5. If you've connected everything correctly, the CHARGING
LED should be lit, indicating that the charger is charging, and the POWER
(red) LED will go off. If the CHARGING
connections or have the battery checked/replaced.
6. When the battery is fully charged, the CHARGED
7. When charging is complete, disconnect the charger from the AC power,
disconnect the negative clamp, and finally the positive clamp.
8. A marine (boat) battery must be removed and charged on shore.
USING THE QUICK-CONNECT CABLE CONNECTORS
Connect either of the two output cable assemblies to the charger in a matter
of seconds. Make sure to place the charger on a dry, non-flammable surface.
IMPORTANT: Never connect the clamp and ring terminal connectors together
for use in other applications, such as external battery or other power source
charging, or to extend the output cable length, as reverse polarity and/or
overcharge conditions will occur.
BATTERY CLAMP QUICK-CONNECT
1. Connect the end of the charger output cable to the end of the battery clamp
quick-connect.
2. Follow the steps in previous sections to connect the output clamps to the battery.
3. After a good electrical connection is made to the battery, plug the power cord
into a grounded 120V AC electrical wall outlet.
(red) LED will go off. If the CHARGING
LED does not light, check the
• 8 •
yellow/
(
LED does not light,
(green) LED will pulse.
(red) LED will light.
yellow/orange)
(
(green) LED will pulse.