Maintenance And Care; Troubleshooting And Error Codes - Schumacher Electric XC75 Manual Del Usuario

Ocultar thumbs Ver también para XC75:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

12. MAINTENANCE AND CARE

A minimal amount of care can keep your
battery charger working properly for years.
• Clean the clamps each time you are
finished charging. Wipe off any battery fluid
that may have come in contact with the
clamps to prevent corrosion.
• Occasionally cleaning the case of the
charger with a soft cloth will keep the finish
shiny and help prevent corrosion.

13. TROUBLESHOOTING AND ERROR CODES

Error Codes
ERROR
CODE
The battery voltage is
still under 10V (for a 12V
battery) or 5V (for a 6V
F01
battery) after 2 hours of
charging.
The charger cannot
F02
desulfate the battery.
The battery was unable
to reach the "full charge"
F03
voltage.
The connections to the
F04
battery are reversed.
The charger was unable
to keep the battery fully
F05
charged in maintain mode.
The charger detected that
the battery may be getting
F06
too hot (thermal runaway).
If you get an error code, check the connections and settings and/or replace the battery.
DESCRIPTION
• Coil the input and output cords neatly when
storing the charger. This will help prevent
accidental damage to the cords and charger.
• Store the charger unplugged from the AC
power outlet in an upright position.
• Store inside, in a cool, dry place. Do not
store the clamps clipped together, on or
around metal, or clipped to the cables.
REASON/SOLUTION
The battery could be bad. Have it checked or
replaced.
The battery could not be desulfated; have it
checked or replaced.
May be caused by trying to charge a large
battery or bank of batteries on too low of a
current setting. Try again with a higher current
setting or have the battery checked or replaced.
The battery is connected backwards. Unplug
the charger and reverse the connections to the
battery.
The battery will not hold a charge. May be
caused by a drain on the battery or the battery
could be bad. Make sure there are no loads
on the battery. If there are remove them. If
there are none, have the battery checked or
replaced.
The charger automatically shuts the current off
if it detects the battery may be getting too hot.
Have the battery checked or replaced.
• 8 •

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Xc75wXc103Xc103w

Tabla de contenido