Fitting Accessories - Silverline 394970 Traducción Del Manual Original

394970

Fitting Accessories

WARNING: Always disconnect the tool from the air supply before examining or changing
accessories. Examine your chisels before using them. If an accessory is worn or cracked, DO NOT use.
1. Insert the required accessory into the head of the air hammer
2. Thread the Quick Change Spring (1) over the accessory and onto the screw threads on the
head of the air hammer
3. Tighten the Quick Change Spring (1) so that the screw threads are fully engaged, the end loop
is positioned vertically (12 o'clock position), and the shank of the accessory is retained within
the end coil, as shown in the 'Product Familiarisation' image above
4. Pull the accessory back and forth several times by hand, to check that it is securely retained
Note: Accessories can also be removed and fitted when the Quick Change Spring (1) is screwed on
to the body of the tool. Carefully push the end coil of the spring sideways, so that the collar of the
accessory can pass the retaining spring coil.
Setting Tool Power
Note: This air hammer features a built-in pressure regulator.
• The tool speed can be adjusted by rotating the Air/Torque Control Dial (4) as required
Operation
1. Grip the air hammer firmly with both hands
2. Rest the tip of the accessory on the workpiece you wish to chip/cut
3. Gently press the trigger and move slowly along the workpiece
Note: DO NOT allow the air hammer to run in 'idle rotation' for an extended period of time. This
will shorten its life.
Note: DO NOT exert excessive pressure on the tool - let the tool do the work. If the material is
not being cut as intended, examine the accessory for wear and damage and replace if necessary.
Consider changing to a different accessory.
WARNING: Be aware that air tools may hold residual pressure after use. Always bleed air pressure
from the tool after shutting off air supply.
Accessories
• Accessories for this tool, including a 4pce Chisel Set (598430), are available from your Silverline
stockist. Other spare parts can be obtained from your Silverline dealer or
www.toolsparesonline.com
Air Hammer Set 5pce
Maintenance
WARNING: Always disconnect from the air supply and depressurise before cleaning or carrying out
any maintenance
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry cloth
IMPORTANT: There is very little that can go wrong with your air tool and it should be noted that
when an air tool fails to work it is generally because the internal workings have corroded due to
dirty, wet air and failure to follow the instructions given below.
Daily maintenance procedure: Disconnect from the air supply, pour the equivalent of a
tablespoon of oil into the air intake. Operate the machine at low speed to thoroughly lubricate all
internal workings.
• If the machine is in constant use or used for long periods at a time, a combined filter/lubricator
must be fitted. There must be an air filter fitted at all times
• Use air tool oil. DO NOT UNDER ANY CIRCUMSTANCES USE NORMAL ENGINE OIL
• Failure to comply with the operating and maintenance instructions may invalidate the guarantee
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
• As with other power tools, air tools should not be disposed of with household waste
• Air tools may contain traces of tool oil and other lubricants and so must be recycled accordingly
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
silverlinetools.com
7