Before Use; Product Familiarisation; Intended Use; Unpacking Your Tool - Silverline 394970 Traducción Del Manual Original

GB
Air Hammer Safety
• Air hammers and chisels can produce large amounts of vibration. Some workpieces (like sheet
metal, car body parts, etc.) will amplify sound and vibration and can start to ring
• Any spectators in the vicinity of the work area must wear eye and hearing protection
• Chiselling can lead to chips of material flying off, and to dust being created
• Be aware of paint finishes or treatments that may have been applied to the material that is being
worked on. Many treatments can create toxic chips or dust, or otherwise harmful substances
• Dusts are particularly hazardous to children, pregnant women, and people with high blood
pressure. Do not allow these people to enter the work area, even if wearing appropriate personal
protective equipment

Product Familiarisation

1 Quick Change Spring
2 Trigger
3 Quick Connector
4 Air/Torque Control Dial
Included Accessories:
5 Panel Cutting Chisel
6 Taper Punch
7 Spot Weld Breaker Chisel
8 Ripping Chisel

Intended Use

Air hammer, powered by compressed air from a compressor, designed primarily for use on vehicle
bodywork and similar thin sheet metal constructions.

Unpacking Your Tool

• Carefully unpack and inspect your tool. Fully familiarise yourself with all its features and
functions
• Ensure that all parts of the tool are present and in good condition. If any parts are missing or
damaged, have such parts replaced before attempting to use this tool
6

Before Use

Fitting the Quick Connector
Note: This tool is supplied with two different male airline quick connectors:
EQ-4 – commonly used in Europe
EN-6 – mainly used in the UK
EQ-4
Europe
• Please choose the connector that is compatible with the airline system you are using, and install
as outlined below:
1. Apply PTFE tape (not included) to the screw threads of the Quick Connector (3). This will help
to maintain an air tight seal
Note: Apply PTFE tape tightly and in a clockwise direction, so it does not come off when the
thread is screwed into the tool.
2. Remove the protective plug from the air inlet
3. Using a spanner (not included) screw the quick connector into the air inlet located at the
base of the handle
4. Connect to airline, pressurise carefully and carry out a leak check (e.g. by spraying
small amounts of soapy water on to the outside of the connectors)
• Air lines fitted with matching female quick connectors will now be a push fit to the tool
Air Supply Connection
QUICK COUPLER
TO YOUR NIPPLE
AIR TOOL
RECOIL HOSE
LEADER HOSE
• This tool should be connected to a clean, dry air supply with inline oiler and water separator
• Do not allow supply pressure to exceed the maximum stated (see "Specifications")
• Ensure that water is drained from air system daily
• Ensure that all parts of the system (hoses, couplers, etc.) are correctly rated for the air pressure
to be used
EN-6
UK
WATER SEPARATION
NIPPLE
OILER
DRAIN DAILY
REGULATOR AIR SUPPLY