Connections And Control Devices; Water Connection; Starting Procedure - ESAB Warrior Feed 304 Manual De Instrucciones

US
8.1

Connections and control devices

1 Display voltage (V)
2 Display current (A)
3 Knob for setting the wire feed speed
4 Knob for setting the voltage
5 Switch for wire inching or gas purge
6 RED connection for cooling water from
welding torch
7 BLUE connection for cooling water to the
welding torch
8 Connection for the welding torch
NOTE! Cooling water connections only available on certain models (Warrior Feed 304w).
8.2

Water connection

When connecting a water-cooled welding torch, the power source's main power
supply switch must be in the 0-position and the cooling unit switch must be in
position 0. Turn the cooling unit to position 1 before start welding.
A water connection kit can be ordered as an option, see accessories from page 64.
8.3

Starting procedure

When the wire feed starts, the power source generates the welding voltage.
If there is no welding current flow within three seconds, the power source switches
the welding voltage off. The wire feed continues until the welding torch's switch is
switched off.
bm55d1a
9 Switch for creep start (inside)
10 Switch for 2-stroke/4-stroke (inside)
11 Connection for welding current from power
source (OKC)
12 Connection for control cable from power
source
13 Connection for shielding gas
14 BLUE connection for cooling water from
power source (cooling unit)
15 RED connection for cooling water to power
source (cooling unit)
- 16 -
© ESAB AB 2013