Accessories; Use; Maintenance - Imetec MAX POWER ANIMAL CARE Instrucciones Para El Uso

Your appliance is equipped with the following attachments:
MULTI-SURFACE brush (5): The multi-surface brush (5) is suitable for all surfaces:
ceramic, marble, parquet and carpets.
ANIMAL CARE TURBO BRUSH (6): specific for easily removing animal hairs from any surface.
suitable for all surfaces: ceramic, marble, parquet, carpets and rugs without fringes.
If the brush is too stuck to the rug or surface that you are vacuuming, by slowing down rotation, open
the air nozzle slider (6c) by moving it to the right.
DO NOT use the Animal Care turbo brush on rugs with fringes, animal furs and
carpets with a deep pile, longer than 15mm.
DO NOT hold the brush still on the carpet while the roller is spinning
ATTENTION! Rotating parts in motion. Trapping hazard.
• pull the power cable (3) all the way out to the red mark. The yellow mark on the cable is
before the end part of the cable with the red mark.
• Hook the cable inside the cable eyelet (1a) [Fig. B3] located just under the handle to
prevent it from getting in the way during cleaning. [Fig. B4]
Using the vacuum cleaner with the cable fully or partly wound involves
an overheating hazard!
NOTE:
1. Bear in mind that a new appliance can develop odours the first few times it is
used. These odours are harmless and disappear shortly afterwards. Ventilate
the room.
2. Transparent parts can become opaque, due to use.
• plug the power cable into the socket and turn the appliance on from the oN/oFF switch
(2) (position I).
• The electronic power control (15) allows you to adjust the suction force. select the
following settings [Fig. c1]:
Minimum or intermediate level: for rugs and carpet.
Maximum: for floors and parquet.
• switch the appliance off after use, by pressing the oN/oFF button (2) (position o) and
disconnect the plug from the socket.
• press the automatic cable winding key (14B) to wind up the power cable [Fig. c2]. Hold
the plug while winding the cable in order to prevent whiplash.
Switch the appliance off and disconnect the plug from the socket before
opening the appliance! Make sure all cleaned parts are completely dry
before reusing the appliance.

ACCESSORIES

USE [Fig. C]
MAINTENANCE [Fig. D]
EN
11