LG LRG3061ST Manual Del Propietário página 39

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9
Once the oven cavity is cleaned, wipe any
excess water with a clean dry towel. Replace
racks and any other accessories.
10
If some light soils remain, repeat the above
steps, making sure to thoroughly soak the
soiled areas. If stubborn soils remain after
®
multiple EasyClean
remove any burnt-on debris with a scraper.
nOTE
• If you forget to saturate the inside of the oven
with water before starting EasyClean
Clear/Off to end the cycle. Wait for the range
to cool to room temperature and then spray
or pour water into the oven and start another
®
EasyClean
cycle.
• The cavity gasket may be wet when the
®
EasyClean
cycle finishes. This is normal. Do
not clean the gasket.
• If mineral deposits remain on the oven bottom
after cleaning, use a cloth or sponge soaked in
vinegar to remove them.
• It is normal for the fan to operate during the
EasyClean
®
cycle.
• If a self-clean option is not available, scrape off
and remove stubborn soil using a scraper.
Cleaning Tips
• Allow the oven to cool to room temperature before
®
using the EasyClean
cycle. If your oven cavity is
above 150 °F (65 °C), Hot will appear in the display,
®
and the EasyClean
cycle will not be activated until
the oven cavity cools down.
• Using the rough side of a non-scratch scouring pad
may help to take off burnt-on stains better than a
soft sponge or towel.
• Certain non-scratch scrubbing sponges, such as
those made of melamine foam, available at your
local stores, can also help improve cleaning.
• The range should be level to ensure that the bottom
surface of the oven cavity is entirely covered by
water at the beginning of the EasyClean
• For best results, use distilled or filtered water. Tap
water may leave mineral deposits on the oven
bottom.
• Soil baked on through several cooking cycles will
be more difficult to remove with the EasyClean
cycle.
• Do not open the oven door during the EasyClean
cycle. Water will not get hot enough if the door is
opened during the cycle.
cycles, Scrape off and
®
, press
®
cycle.
®
®
Using the Scraper
The retractable razor scraper included with the range
can be used to help remove stubborn soil from inside
the oven.
1
To use the scraper, depress the button and slide
it forward to extend the blade.
2
Scrape the surface of the oven, sliding the blade
parallel to the surface. Do not gouge at the oven
surface with the tips of the blade.
3
When finished, carefully clean the blade with
a cloth, keeping fingers away from the sharp
edges of the blade. Depress the button and slide
it backward to store the blade.
replacing the Scraper Blade
If the scraper blade becomes dull or damaged,
remove and replace it.
CAUTIOn
Keep fingers away from sharp edges of blade.
1
To remove the blade, depress the scraper's
button and slide it forward to extend the blade.
2
Hold the scraper as shown, with one end of the
blade resting on the edge of a table or other flat
surface.
3
Carefully push down on the scraper handle to
slide the blade free from the handle.
4
To insert a new blade, align the back of the blade
with the groove in the scraper handle. With the
end of the blade against a flat surface, carefully
push the handle down to slide the blade into
position.
MAINTENANCE
39

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Lrg3061bd

Tabla de contenido