4
IMPORTANT SAFETY INSTRUCTIONS
IMPOrTAnT SAFETY InSTrUCTIOnS
Read and follow all instructions when using the range to prevent the risk of fire, electric
shock, personal injury, or damage. This guide does not cover all possible conditions that
may occur. Always contact your service agent or manufacturer about problems that you do
not understand.
Download this owner's manual at: http://www.lg.com
This is the safety alert symbol. This symbol alerts you to potential hazards that
can result in property damage and/or serious bodily harm or death.
All safety messages will follow the safety alert symbol and either the word
WARNING or CAUTION. These words mean:
WArnInG
- Indicates a hazardous situation which, if not avoided, could result
CAUTIOn
AnTI-TIP DEVICE
WArnInG
• ALL RANGES CAN TIP
• INJURY TO PERSONS COULD RESULT
• INSTALL ANTI-TIP DEVICES PACKED WITH RANGE
• SEE INSTALLATION INSTRUCTIONS
• To avoid tipping, do not step or sit on the door. Install the anti-tip bracket packed with this
range.
- The range could be tipped and injury might result from spilled hot liquid, food, or the
range itself.
- If the range is pulled away from the wall for cleaning, service, or any other reason,
ensure that the anti-tip device is properly reengaged when the range is pushed back
against the wall.
Approximately
0.65" (16.5 mm)
• To reduce the risk of the range tipping over, the range must be secured by properly
installing the anti-tip device.
• To check that the anti-tip bracket is properly installed: Remove any items on the cooktop.
Grasp the top rear edge of the range back guard and carefully attempt to tilt it forward.
Verify that the anti-tip device is engaged.
• Remove the warming or storage drawers and visually inspect that the rear leveling leg is
fully inserted into the anti-tip bracket.
• Refer to the installation section of the manual for proper anti-tip bracket installation.
- Indicates a hazardous situation which, if not avoided, could result
in death or serious injury.
in minor or moderate injury.
Anti-tip bracket
Wall plate
Screw must
enter wood or
concrete