Dry Vacuum Operation - EWT CS 5 COMFORT Manual De Instrucciones

DRY – VACUUM OPERATION
1
6
BEFORE YOU START
WARNING!
You must first read and understand the section on "precautions and
guidelines regarding safety" and take them into account.
Guidelines: Never vacuum dangerous substances.
The use of an unsuitable dust bag will result in the cancellation of
the guarantee.
When vacuuming fine dust (plaster, cement, etc.), always use a
cartridge filter together with a fine dust bag (optional). If these are
not in place, dust and particles may penetrate the motor and
damage it. If these instructions are not followed, the guarantee may
be cancelled.
1. Make sure the appliance is not plugged into the mains (Fig. 1).
2. To prepare your appliance for vacuuming dust, check that the cartridge filter is clean and dry and
place it correctly in the centre of the filter housing.
Push down until the elastic fits right around the upper part of the float cage (Fig. 2).
3. Check that the filter completely covers the float cage. Also check that the edges of the cartridge filter
are correctly placed under the elastic ring (Fig. 3).
4. Slide the dust bag over the suction port on the container. Press down until it is firmly in place. Take
care not to damage the dust bag (Fig. 4).
5. Replace the upper part on the container and fix with the container clasps (Fig. 5).
2 3
7 8
4
37
5