Troubleshooting - Silverline 521333 Manual Del Usuario

GB

Troubleshooting

Problem Possible cause Solution
No power Check power supply
No function when ON/OFF Switch
(1) is operated
Defective ON/OFF Switch Have the ON/OFF Switch replaced by an authorised Silverline service centre
Slow material removal Sanding sheet too fine or worn Fit new sanding sheet with coarser grit
Sanding sheet too coarse Fit new sanding sheet with finer grit
Scratches on workpiece
after sanding
Not enough material removed Continue sanding
Sanding sheet incompatible with material Fit correct sanding sheet
Burn marks on workpiece
Too much pressure exerted on to the sander Use less pressure whilst moving the tool
Dust extraction not working; sanding sheet not aligned
Excessive dust emission with dust extraction holes in the Sanding Base Plate (7); Realign sanding sheet; unblock dust extraction holes
extraction holes blocked
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
10