Charging The Battery - Dymo XTL 500 Guia De Inicio Rapido

Charging the Battery

The label maker is powered by a rechargeable, Lithium Polymer (LiPo) battery. The
battery, included with your label maker, is already installed and is partially charged.
A power adapter is included with your label maker for recharging the battery. Fully
charging the battery will take approximately 2.5 hours.
Lift the connector cover on the
1
side of the label maker and turn
clockwise. See Figure 4.
Plug the power cord into the
2
power adapter. See Figure 5.
Plug the power adapter into the power connector, and then plug the power cord
3
into a power outlet. See Figure 5.
Power adapter
Make sure to read the LiPo Safety Precautions found on page 11.
4
Lift and turn
clockwise
Power connector
Power cord
Figure 4
Figure 5