Programming (T Model Only) - Astralpool APR-3 Serie Instrucciones De Funcionamiento

4.1 Programming (T Model only)

Setting Current Time/Day
(a) Select POOL MODE Standby/Off
(b) Press the CLOCK button
(c) Press DAY to change the current day.
(d) Press HOUR to move the Display cursor to the hour digits and then use the Up and
Down arrows to the right of the display to change the current hour
(e) Press MIN to move the Display cursor to the min digits and then use the up and down
arrows to the right of the display to change the current minutes
(f) Press the CLOCK button to exit the clock setting mode.
Setting Timers
Your Chlorinator has 4 timers enabling you to set four different periods in which your
chlorinator/pump will operate. Different periods can be set for the weekend compared to
weekdays. Timers are set by entering a start time, and a period for how long you want to
operate (i.e. Mon – Fri T1 On 14:00 and Mon – Fri T1 Period 6:15 will run the
chlorinator/pump during weekdays from 14:00 for 6.25 hours). To set timers, do the following:
(g) Select POOL MODE Standby/Off
(h) Press the TIMER button to step to the timer you want to set
(i) Press DAY button to step from Mon-Fri to Sat-Sun and Visa versa
(j) Press HOUR button to set the hour for the timer selected and use the Up/Down arrows
to change the time. NOTE: Hour digits go from Not Used and then 0 to 23. If you
don't want to use this timer, select Not Used.
(k) Press MIN button to select the minutes for the timer selected and use the Up/Down
arrows to change the time. Press the TIMER button to select the Period or another time
and set as required.
(l) When finished, press the TIMER button a number of times to scroll through the other
times until you return to normal display. This saves your new settings.
(m)Select POOL MODE Auto
APR Salt Chlorinator (V3) Page 6