Chlorine Output; User Mode - Astralpool APR-3 Serie Instrucciones De Funcionamiento

Programming Recommendations
AstralPool recommend that you use two timers, one for the morning and one for the evening
and typically for periods of 2-5 hours for each. Your chlorinator is most effective if running in
the early morning or evening when it is cooler (strong sunlight consumes more chlorine). As a
default, the control is set to come on at 08:00 and 16:00 both for periods of 4 hours.

4.2 Chlorine Output

The Chlorine Output Control area of the user panel has three main functions:
(a) Increase/Decrease arrows for setting the chlorine output level of the chlorinator. The
chlorinator output can be set from levels 1 through to 8. This level only applies to Pool
Mode. When the Chlorinator is in Spa mode, the chlorine output will be at level 1
(b) Chlorine Output display shows the level set
(c) The LCD display will also show a output level from 1 to 8 which indicates the
performance of the chlorinator compared to the Chlorine Output LED's.
LCD output level (1 to 8) be less than the LED output, check salt level in pool. Should
salt level be at 4000 ppm and output more than 2 settings less than LED display, you
cell may need replacing.
4.3 User Mode (T Model only)
The user mode buttons enable you to select Pool or Spa mode and to manually control the
Chlorinator/Pump. Functions are as follows:
(a) POOL MODE: Sends a message to other AstralPool equipment (if fitted) to go to Pool
mode. There are 3 Pool Modes
Auto
On
Standby/Off
(b) SPA MODE: Sends a message to other AstralPool equipment (if fitted) to go to Spa
mode and turns the pump on
APR Salt Chlorinator (V3)
The Chlorinator/Pump will run according to how you have set the
timers
The Chlorinator/Pump will run continuously.
The Chlorinator/Pump will stay off continuously.
Should the
Page 7