Garland APACHE 675 SL Manual Do Operador página 45

case, more than absolutely necessary do not tilt it,
and lift only the part farthest from the operator.
6.4.2.1. COLD-STARTING THE ENGINE
Place the machine on a flat and stable surface in
order to start it.
Press the primer bulb several
times to ensure that the fuel
has reached the carburettor.
(depending engine model).
Push the safety switch bar until
it touches the upper handle.
Allow the engine to warm up for a few minutes
before starting to use the machine.
6.4.2.2. STARTING WITH A HOT ENGINE
Place the machine on a flat and stable surface in
order to start it.
Push the safety switch bar until it touches the upper
handle.
Place yourself behind the
mower as shown in the
figure and pull the Starter
rope until the engine starts.
Place yourself behind the mower and pull the Starter
rope until the engine starts.
If after a few tries the engine does not start, follow
the instructions for starting cold-starting the engine.
6.5. STOPPING THE ENGINE
Turn of the engine by releasing the safety switch.
6.5. TRACTION DRIVE
Press the traction handle against the handlebar, as
shown in the figure, and the mower traction will start
operating.
6.6. CHECKPOINTS AFTER STARTING THE
MACHINE
It is important to pay attention to the possible
individual parts or and the temperature of the
machine. If you detect any anomaly in the machine
immediately stop and check it carefully.
45/184
English