Garland APACHE 675 SL Manual Do Operador página 48

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
English
Rear discharge cut:
Configuration in which the cut grass will come out
from the rear of the machine leaving the grass debris
on the lawn. In this case, the machine must not have
the bag installed, the rear outlet cover will remain
slightly open.
Place the mower in a corner of the lawn area to be
cut and set the desired cutting height.
Make sure that the blade is not in contact with any
object, and start the mower.
Walk on the grass to the rhythm of the mower.
Do not tilt the machine with the engine running
except in the case that you have to start cutting tall
grass, which is the only case in which you may raise
the front wheels slightly to facilitate entry of the
mower to the work area.
Note: If the grass is very high it will be difficult for
you to start the engine. If the grass is very high, you
should slightly raise the lawnmower's front wheels,
forcibly pushing down with the handle, and start
your lawnmower in this position. Once the engine
has acquired the normal engine speed slowly lower
the mower wheels while the machine starts to cut.
Alternatively, if next to the lawn area there is a flat
surface free of objects and without grass (Earth,
screed, concrete), start the lawnmower in the clear
area and entering the grass area by slightly lifting the
front wheels of the lawnmower.
If the engine's rotation speed goes into excess or
it stops, it means that the grass is too high for the
lawnmower's cutting capacity and forcing this can be
harmful to the machine. In this case, make a first cut
at the machine's maximum height and then a second
cut at the desired height.
7.4. EMPTYING THE BAG
Empty the lawnmower's bag as soon as you notice
it is full. You will notice that the bag is full because
the mower will stop picking up the cut grass as well,
leaving many remains on the ground.
Whenever you are going to empty the bag, turn off
the engine and check that the blade has stopped
before removing the bag.
1. Lift the lid from the rear exit.
2. Lift the sack.
3. Remove the bag back.
4. Empty the bag.
5. Lift the lid from the rear exit.
6. Place the bag by hooking the protrusions on the
chassis of the bag to the recess of the handlebar
attachment.
7.5. RECOMENDATIONS
Always cut the grass when it is dry. Avoid mowing
the lawn when it is wet after having watered or after
having rained.
48/184

Publicidad

Tabla de contenido
loading

Tabla de contenido