Publicidad
Step 10
Unfold the LARGE BACK (H2) and lay it over your unit.
å
Make equal margins along all four edges of the LARGE BACK (H2). Push on opposite corners of your unit if needed to
å
make it "square".
A perforation in the LARGE BACK (H2) has been provided for access to the SAFETY STRAP (60M). Punch out the
å
perforation and push the SAFETY STRAP through the hole.
Fasten the LARGE BACK (H2) to three edges of your unit using the NAILS (1N). The NAILS should be 5-1/2" apart, 1-1/2"
å
from the corners, and 1/4" in from the edges. Also, be sure the NAILS are 1/2" from each fold line in the BACK.
NOTE: Do not tap nails into the bottom edge of the LARGE BACK at this time.
å
Position the BACK (I) over the lower portion of your unit, making equal margins along the bottom and side edges. Fasten
å
the BACK (I) to three edges of your unit using the NAILS (1N).
NOTE: The BACK (I) will overlap the LARGE BACK (H2) as shown in the enlarged diagram. Fasten the BACK and LARGE
å
BACK to the SHELF (G2) using the remaining NAILS (1N).
(55 used in this step)
Do not fasten NAILS
along this edge until the
BACK (I) is overlapping
the LARGE BACK (H2).
Page 14
1N
NAIL
I
H2
H2
I
The BACK (I)
G2
overlaps the
LARGE BACK (H2).
423033
Before fastening the
BACK, punch out the
1"
perforation and push
60M
the SAFETY STRAP
through the hole.
1/2"
5-1/2"
1/4"
www.sauder.com/services
1-1/2"
Publicidad
