Flex FX2241 Manual Del Operador página 10

d. Try to push in or pull out the blade to check
whether it is locked properly.
NOTICE: The blade may be installed with the
teeth pointing up or down, depending on the
cutting operation.
TO REMOVE THE SAW BLADE (FIG. 3C):
Rotate the tool-less blade clamp sleeve in the
direction of the arrow marked on the blade
clamp, the blade will get ejected out.
The tool-less blade clamp sleeve will stop in
place for the future blade installation.
NOTE: Occasionally the tool-less blade
clamp may retract into the saw housing. If this
happens, reattach the battery pack and turn the
tool on by pressing the variable-speed trigger
switch to move the blade clamp into a more
accessible position. Remove the battery pack
again.
WARNING
blade does not point at any person or animal
to avoid personal injuries.
WARNING
the blade to cool down or wear gloves when
removing a saw blade.
WARNING
warning could cause loss of control and can
result in possible serious injury.
When removing the saw
blade, make sure the saw
The saw blade may be
very hot after use. Allow
Use only a correct saw
blade. Failure to heed this
Fig. 3b
Fig. 3c
-10-