Flex FX2241 Manual Del Operador página 13

To unlock the switch, push the side of the
lock-off button marked
(Fig. 5b).
VARIABLE-SPEED TRIGGER SWITCH (FIG. 6)
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned ON or
OFF by depressing or releasing the variable-
speed trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
LED LIGHTS (FIG. 7)
Your tool is equipped with two LED lights,
located near the blade clamp on the tool.
These LED lights provide additional light on the
surface of the workpiece for operation in lower-
light areas.
The LED will automatically turn on with a slight
squeeze on the variable-speed trigger switch
before the tool starts running and will turn off
approximately 10 seconds after the variable-
speed trigger switch is released.
The LED will rapidly flash when the tool and/or
battery pack becomes overloaded or too hot.
to the far right
Fig. 5b
Unlock
Fig. 6
Variable-Speed
Trigger Switch
Fig. 7
-13-
LED Lights