Prepare The Site - Kohler K-11842 Guía De Instalación Y Cuidado

Ocultar thumbs Ver también para K-11842:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Finished
Wall
*
*Consult the spout
specification sheet
for specific installation
dimentions.

2. Prepare the Site

IMPORTANT! The valve requires special framing and support
considerations. Consult the specification sheet for the spout that will
be installed with your valve at www.kohler.com for specific
dimensions.
NOTE: Mount the valve with the sensor at the height determined in
the previous step.
NOTE: A suggested framing example is shown. Each installation
may have different framing requirements than those shown.
Construct the framing for your installation.
If a thermostatic mixing valve will be included with your
installation, install the valve now following the directions
provided with the valve.
3. Secure the Valve
IMPORTANT! Make sure the location of the valve is correct before
securing it in place. The centerline of the drain and faucet should be
in line with each other.
1207552-2-B
Six Round Holes (Typical)
Wall Plate
Screws
16"
(406 mm)
7" (178 mm)
*
2x4 Stud Framing
Sink Height
6
Kohler Co.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K-11843

Tabla de contenido