Troubleshooting - CAMPAGNOLA MC Serie Manual De Uso Y Mantenimiento

Check the compressor oil level
Let the engine run for about 2 minutes
Change the compressor oil
Check the belts tension
Clean all the external parts of the compressor
Empty the fuel tank and use up the carburettor residual
content
As for the commercial components of the machine and their use and maintenance instructions, as well as
more information about the periodical controls, see the corresponding Use and Maintenance Manuals enclosed,
indicated in chapter 9.
For details about the operative modes please refer to this manual, above all to par. 7.1 and 7.2.
8.

TROUBLESHOOTING

The following chart shows the list of the possible problems regarding the system supplied.
The column named "Cause" shows the reason of the problem.
The column named "Solution" shows the operations to perform to solve the problem.
PROBLEM
Drop in air tank pressure while
machine and tools are not in use
Overheating of the compressor head
block (2)
Pressure over 11 bar and safety
valve (4) releasing air
Pilot valve/unloader (5) making a
cracking noise
The compressor head block (2)
pressure remains low
The tools do not work perfectly (slow
down).
The tools do not work at all
Campagnola Srl
CAUSE
Air leaks from the connections
obstruction of the upper guard grids
unloader (5)
unloader (5)
• Slipping drive belt (20)
or valves breakage
Lacking lubrication in the connected
tools
X
X
X
SOLUTION
water. The leak will be shown by
air bubbles.
Check the grids or blow air among
Take the machine to an Authorised
Service Point.
Take the machine to an Authorised
Service Point.
• Reset the belt tension or replace it.
• Take the machine to an Authorised
Service Point.
Check the oil and the dosing level
of the air lubricating unit.
according to the manual instructions
of the connected tools.
X
X
X
X
X
X