Stihl MS 201 Manual De Instrucciones página 44

English
Version with Easy2Start
Remove remaining rope from the
N
rotor and starter grip
Thread the new starter rope through
N
the starter grip and secure it by
making a knot
42
Installing the rope rotor
Version with ElastoStart
1
Thread the rope from above through
N
the rope guide bush (1) and rope
rotor (2) and secure with a simple
overhand knot
Coat the bearing bore in the rope
N
rotor with non-resinous oil
Slip the rope rotor onto the starter
N
post (3) – turn it back and forth a
little until the anchor loop of the
rewind spring engages
6
4
Refit the pawl (4) in the rotor and
N
slip the washer (5) over the starter
post
Press the spring clip (6) on to the
N
starter post and over the pegs of the
pawl with a screwdriver or suitable
pliers – the spring clip must point in
2
the clockwise direction – as shown
in the picture
5
MS 201, MS 201 C