Stihl MS 201 Manual De Instrucciones página 45

Version with Easy2Start
1
Thread the rope from above through
N
the rope guide bush (1) and rope
rotor (2) and secure with a simple
overhand knot
Coat the bearing bore in the rope
N
rotor with non-resinous oil
Slip the rope rotor onto the starter
N
post (3) – turn it back and forth a
little until the anchor loop of the
rewind spring engages
MS 201, MS 201 C
Push the carrier onto the post until
N
the anchor loop of the spring
engages
2
4
Refit the pawls (4) in the carrier and
N
slip the washer (5) over the starter
post
Press the spring clip (6) on to the
N
starter post and over the pegs of the
pawl with a screwdriver or suitable
pliers – the spring clip must point in
the clockwise direction – as shown
in the picture
Tensioning the rewind spring
N
6
5
N
4
N
N
The starter grip must be drawn firmly
into the rope guide bush. If it tips
sideways: increase the spring tension by
another turn.
N
N
Replacing broken rewind spring
N
Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow
Hold the rope rotor tight – pull out
the twisted rope and untangle it
Release the rope rotor
Slowly let go of starter rope so that
it winds onto the rotor
When the starter rope is fully
extended it must be possible to
rotate the rotor at least another
half turn. If not, the spring has
been tensioned too tightly and
may break!
Remove one turn of the rope from
the rotor
Mount the fan housing on the
crankcase
Remove the rope rotor
English
43