Oil Quantity Control; Taking Care Of The Guide Bar - Stihl MS 201 Manual De Instrucciones

English
Short-term storage
Wait for engine to cool down. Keep the
machine with a full tank of fuel in a dry
place, well away from sources of
ignition, until you need it again.
Long-term storage
See "Storing the machine"
36

Oil Quantity Control

Varying cutting lengths, types of wood
and work techniques require varying
amounts of oil.
1
The oil flow can be adjusted as needed
using the adjusting screw (1) on the top
of the machine.
Ematic position (E), medium oil flow –
Turn adjusting screw to "E" (Ematic
N
position)
To increase oil flow –
turn the adjusting screw clockwise
N
To reduce oil flow –
turn the adjusting screw
N
counterclockwise
The chain must always be coated
with oil.
Taking Care of the Guide
Bar
2
1
Turn the bar over – every time you
N
sharpen the chain and every time
you replace the chain – this helps
avoid one-sided wear, especially at
the nose and underside of the bar.
Regularly clean the oil inlet hole (1),
N
the oilway (2) and the bar
groove (3).
Measure the groove depth – with
N
the scale on the filing gauge (special
accessory) – in the area used most
for cutting.
MS 201, MS 201 C
3