Festool LEX 2 185/7 Manual De Instrucciones página 8

lubricates the compressed air and keeps it free of
condensation. Here, the lubricator should be set so
that a drop is applied to the compressed air approx.
every 7-10 minutes.
Damage that occurs as a result of incorrect com-
pressed-air processing is excluded from warranty
claims.
 We recommend a service unit with a 3/8" con-
nector, when up to two Festool pneumatic tools
are used.
A compressor that supplies at 500 l/min and at an
operating pressure of 6 bar (87 psi) should be used
to supply compressed-air.
The diameter of the piping system must be suffi-
ciently large (at least 9 mm (3/8")).
IAS 3 hose connector
The sander is a pneumatic tool for connection to the
Festool IAS 3 system. This hose system combines
three functions in one hose:
• Compressed-air supply [1-1]
• Exhaust air extraction [1-2]
• Dust extraction [1-3]
Connection and disconnection - see Fig. [2].
1.1
1.2
1.3
8
1
2