Dremel 7300-PGT Instrucciones De Funcionamiento Y Seguridad página 15

2610046266_7300-PGT 3/21/17 10:17 AM Page 15
Assembly Instructions for pet nail grooming
safety measures reduce the risk of starting the tool accidentally.
FIG. 1
To load mandrel:
1. Unscrew and remove the nose cap 1 from the tool
by twisting it counter-clockwise until it comes off
the tool (Fig. 1).
2. To loosen the collet nut, first press shaft lock but-
ton 2 and rotate the collet nut 3 by hand until the
lock engages the shaft preventing further rotation
(Fig. 2).
3. With the shaft lock 2 engaged, loosen the collet
nut 3 (turn counterclockwise L). Use the wrench 7
if necessary. The collet nut must be loosely
threaded on when inserting an accessory (Fig 2).
4. Insert EZ Lock™ mandrel 6 into collet 4 (Fig. 2).
on the collet nut, setting the mandrel to the correct
depth. Failure to set the mandrel to the correct depth
can result in damage to the attachment.
Disconnect battery pack from tool or place the switch in the locked or off position
before making any assembly, adjustments or changing accessories. Such preventive
FIG. 2
T
L
7
1
2
Do not engage shaft lock
while the tool is running.
Make sure the blue spacer 5
on the mandrel bottoms out
FIG. 3
6
5
12
11
4
3
10
9
2
5. With the shaft lock 2 engaged, tighten the collet nut
3 securely (turn clockwise T) with wrench 7 (Fig. 2).
Note: If the EZ Lock™ mandrel does not fit into the
collet, it is possible that the collet is stuck within the
collet nut. If this happens, remove the collet nut from
the tool by continuing to twist it counterclockwise. If
the collet does not separate from the collet nut when
removed from the tool, push the shank of the EZ
Lock™ mandrel 6 into the hole in the collet nut 3. This
should cause the collet 4 to pop out of the collet nut
3. Re-assemble by placing the collet 4 into the output
FIG. 5
6
FIG. 4
12 11
90°
10
9
2
3 4 8
15