Dremel 7300-PGT Instrucciones De Funcionamiento Y Seguridad página 29

2610046266_7300-PGT 3/21/17 10:18 AM Page 29
wood, smooth fiberglass, sand inside curves and
other diffi cult places, and other sanding jobs. You
replace the sanding bands on the drum as they
become worn and lose their grit. Bands come in fine
medium and coarse grades. Flapwheels grind and
polish flat or contoured surfaces. They are used most
effectively as a finishing sander after heavier surface
sanding and material removal is completed.
Flapwheels come in fine and coarse grades. Buffs are
a great finishing accessory for cleaning and light
sanding. They work effectively on metal, glass, wood,
aluminum and plastics. Coarse and medium buffs are
sold together. All buffs are sold individually. Do not
exceed 15,000 RPM in speed. 1/8" shank.
Grinding Wheel
Use for deburring, removing rust, and general purpose
grinding. Use with Mandrel #402.
Cutting Wheels
These thin discs of emery or fiberglass are used for
slicing, cutting off and similar operations. Use them
for cutting off frozen bolt heads and nuts, or to reslot
a screw head which has become so damaged that the
screwdriver won't work in it. Fine for cutting BX cable,
small rods, tubing, cable and cutting rectangular
holes in sheet metal.
Drywall Cutting Bit
Gives you fast, clean cuts in drywall. Use with Dremel
No 565/566 Cutting Guide attachment.
Tile Cutting Bit
Cuts ceramic wall tile, cement board, and plaster.
Use with Dremel No 565/566 Cutting Guide attach-
ment.
Spiral Cutting Bit
Cuts through all types of wood and wood composites.
Use with Dremel No 565/566 Cutting Guide attach-
ment.
High Speed Router Bits
For routing, inlaying, and mortising in wood and other
soft materials. Use with Dremel No. 335 Router
attachment and No. 231 Shaper/Router table.
Brad Point Drill Bits
Titanium coated brad points stay on center and begin
drilling immediately. For use on wood. Size 1/8",
5/32", 3/16", 1/4". 1/8" shank.
HSS Drill Bits
HSS drill bit for use in metal and plastic. Size 1/8",
7/64", 3/32", 5/64", 1/16", 3/64", 1/32". Shank size
matches the drill bit size. Different collet size (481,
482, 483) or Dremel chuck (4486) required according
to drill bit being used.
29