Dremel 7300-PGT Instrucciones De Funcionamiento Y Seguridad página 19

2610046266_7300-PGT 3/21/17 10:17 AM Page 19
sock to cover the toe, foot, and leg of the pet and iso-
late the nail. Push the nail out through a small open-
ing at the tip of the sock to groom the nail. Keep styp-
tic powder on hand in case of bleeding. Styptic pow-
der is available at most pet supply stores. Follow the
directions on the packaging for proper use instruc-
tions.
7300-PGT can also be used with variety of Dremel
accessories that will turn this tool into a carver, a
grinder, polisher, sander, cutter, power brush, drill
and more.
First, reverse the assembly steps on pages 15 and 16
to remove pet grooming attachment, EZ Lock™ man-
drel and reinstall the nose cap.
Dremel accessories such as engraver bits, grinding
stones and mandrels are mounted on the tool using
collet and collet nut system.
FIG. 12
3 4A
3 Collet nut
4A 1/8" collet #480 - no ID rings
4B 3/32" Collet 481 - three ID rings
4C 1/16" Collet 482 - two ID rings
4D 1/32" Collet 483 - one ID ring
9 ID ring
Assembly Instructions for applications
other than pet nail grooming
Collets
8
4B 4C 4D 9
Cleaning the Pet Grooming Attachment
Remove the pet grooming attachment from the rotary
tool as needed to clean out any nail dust or debris.
Wash only the attachment with warm water and dry
thoroughly with a clean cloth before reinstalling on
rotary tool.
7300-PGT comes with the 1/8" collet No 480. There
are also three other collets to accomodate smaller
diameter accessories. Identification (ID) rings will
help you choose the right collet for your bits
(Fig. 12).
To loosen collet nut 3, first press shaft lock button 2
and rotate the collet nut counterclockwise (L) by hand
until the lock engages the shaft preventing further rota-
tion (Fig. 13).
Do not engage lock while the
tool is running.
With the shaft lock engaged, loosen the collet nut by
FIG. 13
T
L
7
2
FIG. 14
5
5
4
3
3
4
8
19