Nickel-Cadmium Batteries; Fcc Caution - Dremel 7300-PGT Instrucciones De Funcionamiento Y Seguridad

2610046266_7300-PGT 3/21/17 10:17 AM Page 9

Nickel-Cadmium Batteries

If equipped with a nickel-cadmium battery, the bat-
tery must be collected, recycled or disposed of in an
environ mentally sound manner.
"The EPA certified RBRC Battery
Recycling Seal on the nickel-
cadmium (Ni-Cd) battery indi-
cates
Corporation is voluntarily partic-
ipating in an industry program
to collect and recycle these batteries at the end of
their useful life, when taken out of service in the
United States or Canada. The RBRC program pro-
vides a convenient alterative to placing used Ni-Cd
batteries into the trash or the munici pal waste
stream, which may be illegal in your area.
The manufacturer is not responsible for radio interfer-
ence caused by unauthorized modifications to this
equipment. Such modifications could void the user's
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received,
including interference that may cause undesired
operation.
NOTE! This equipment has been tested and found to
comply with the limits for a Class B digital devices, pur-
suant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio fre-
quency energy and, if not installed and used in accor-
Robert Bosch Tool

FCC Caution:

Please call 1-800-8-BATTERY for information on Ni-
Cd battery recycling and disposal bans/restrictions
in your area, or return your batteries to a
Bosch/Dremel Service Center for recycling. Robert
Bosch Tool Corporation's involvement in this pro-
gram is part of our commitment to preserving our
environment and conserving
resources."
dance with the instructions, may cause harmful inter-
ference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
• Consult the dealer or an experienced radio/TV
technician for help.
our natural
9