Assembly & Operation - Worx WG162 Manual De Instrucciones

ASSEMBLY & OPERATION
Action
ASSEMBLY
Assembling the Safety Guard
Mounting the Edger Wheel
Installing and Removing the
Battery Pack
Charging the battery pack
More details can be found in
charger's manual
WARNING! The charger
and battery pack are specially
designed to work together so do
not attempt to use any other
devices. Never insert or allow
metallic objects into your charger
or battery pack connections
because of an electrical failure and
hazard will occur.
Operation
Safety ON/OFF Switch
Trimming
12
Adjusting the Shaft
Adjusting the Trimmer Head
Adjusting the Auxiliary handle
Trimming
Using the Flower Guard
Edging
Changing the tool into the Edging
mode
Edging
Manually feeding the line
Replacing the trimmer Spool
Manually winding the line
OPERATION INSTRUCTIONS
1. Automatic line feed system
When initially switching on the trimmer, a small
2 in 1: Trimmer / Edger
length of line is fed out. Each time the tool is started
from rest it will advance about 0.25 inches of trimmer
line.
Figure
A 'clattering' noise will be heard when the lines hit
the Line Cutter. DO NOT BE ALARMED. This is quite
normal. After about 5 seconds the line will be cut to
the correct length and the noise will reduce as the
See Fig. A1 & A2
motor gains full speed.
If the noise of the line being cut can't be heard, more
See Fig. B
line will need to be fed out.
To feed more line, it is first necessary to allow the
trimmer to stop completely; it must come to a
See Fig. C
complete rest, then restart, allowing the motor to
reach full speed.
Repeat above until you hear the line hitting against
the Line Cutter.
2. Manually feeding the line (See Fig. L)
Turn off the trimmer and remove the battery. If
required, line can be fed out manually. To operate,
See Fig. D
press and release manual Line Feed Button, while
gently pulling out the line until it is long enough
to reach the Line Cutter. If the line extends past the
Line Cutter, too much line has been fed out. If too
much line is fed out, remove the Spool Cap and turn
Spool counter-clockwise until the line is at the desired
length.
3. Manually winding the line
(See Fig. N1, N2, N3, N4)
See Fig. E
Take approximately 10ft (3m) of line. Insert 5/8 inch
(15mm) of line into the Spool holes and wind line in
the direction of the arrows on the top of the Spool.
See Fig. F
Leave approximately 4 inches (100mm) of line
unwound and place into the cleat. Ensure that the
See Fig. G1, G2
line is neatly coiled on the Spool. Failure to do so will
impair the efficiency of the automatic line feed. Then
See Fig. H
fit the Spool as shown in Fig. M1, M2, M3
See Fig. I1
MAINTENANCE
See Fig. I2
After use, disconnect the battery from the tool and
check for damage.
Your power tool requires no additional lubrication
See Fig. J1, J2
or maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a
See Fig. K
dry cloth. Always store your power tool in a dry room
temperature location. Keep the motor ventilation
See Fig. L
slots clean. Keep all working controls free of dust.
See Fig. M1, M2,
For Battery tools
M3
The ambient temperature range for the use and
storage of tool and battery is 0
See Fig. N1, N2,
The recommended ambient temperature range for
N3, N4
the charging system during charging is 0
C-45 C.
o o
C-40 C.
o o
EN